Please make sure the you went through the following checklist before the eCognition software gets installed on CentOS

Firewall

  1. Disable the local firewall:
    # service iptables save
    # service iptables stop
    # chkconfig iptables off
  2. Verify the firewall is disabled:
    # service iptables status

SELINUX

  1. Configure SELINUX=disabled in the /etc/selinux/config file:
    # This file controls the state of SELinux on the system.
    # SELINUX= can take one of these three values:
    # enforcing - SELinux security policy is enforced.
    # permissive - SELinux prints warnings instead of enforcing.
    # disabled - No SELinux policy is loaded.
    SELINUX=disabled
    # SELINUXTYPE= can take one of these two values:
    # targeted - Targeted processes are protected,
    # mls - Multi Level Security protection.
    SELINUXTYPE=targeted
  2. Reboot your system. After reboot, confirm that the getenforce command
    returns Disabled:
    # getenforce

FUSE

  1. Install FUSE component
    # yum install install fuse-devel fuse-libs fuse gvfs-fuse
  2. Activate FUSE Kernel Module:
    # modprobe fuse

RedHat LSB

  1. Install Redhat-LSB 64bit and 32bit:
    # yum install redhat-lsb.i686 redhat-lsb.x86_64

lmadmin

  1. Start lmadmin without web-interface
    # lmadmin -noweb

3 comments

  • Dudek,Brian

    There are one two many 'install' options in the FUSE section.

  • Dudek,Brian

    Turning off the firewall and selinux is ill advisable.  I run, serve licenses to clients and have installed eCog 8x with both enabled without any issues.

    RedHat/CentOS 7 does not use iptables for firewall management.

  • 80628262

    Hi Sebastian,Could you kindly send me  the details to instal ecognition on CentOS, Thank you

Your Answer

Articles in this section

Need more help?

Enter Community Contact Support